A simple to build wood burner and the pictures speak for them selves.
A warning that we do not take responsibility for dangers involved with cutting into a gas bottle. We vented the bottle with a air compressor and when we were sure the gas has left the bottle we drilled a couple of holes to ventilate the bottle. The bottle was vented for a few days until all remants of gas or smell had left.
We used a drill and jigsaw with metal cutting blade to cut the openings
Keep the opening cut outs as they will be needed to make the doors. Using 1" flat bar for a flange will be welded on the edge. We used butt hinges (door) welded on to make the door open close.
An angle grinder was used to remove the handles. The gas level indicator can be seen in this calor gas bottle.
A hole is cut in the top to take a flue where the regulator is supposed to be.
I will post more pictures soon.
Don't forget these are gas bottles and you need to excise extreme caution when cutting into a gas bottle.
www.scrollart.co.uk
Aucun commentaire:
Enregistrer un commentaire